![]() ![]() You'll then need to hook in the LiPo to the Powerboost and place them on the back of the case under the Pi, then Sugru and tape it all down, making sure to not cover any of the USB ports or the LED's on the Powerboost as these will show you when its, on, charging, low and finished charging: You'll only need the bottom bit of the case to put on the Pi, with 2 shorter nylon screws on the GPIO side held on with nylon nuts, and 2 longer ones the other side. The heat-sink is easy enough to apply if you opted for one, just peel the back of the sink off and put the sticky side squarely onto the centre chip and hold down firmly a few seconds. ![]() You'll also need to solder on the USB port to the Powerboost, check here for more details on the Powerboost. The Zero Male Header goes onto the Pi itself.Ĭheck this tutorial for adding an on/off switch to the Powerboost 500. So you'll need some basic soldering skills first off to connect the header to the Pi and the other header to the Adafruit hat - I recommend here to learn some basic soldering.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |